Server Video Wall Extron QC 101, QSS 404, Quantum Elite, Quantum Ultra
| Frame rate | 24, 25, 30, 50, or 60 fps | ||
| Chroma sampling | 4:4:4 or 4:2:2 | ||
| Color bit depth | 8 or 10 bits per color | ||
| Signal type | DVI 1.0, HDMI 1.4, and HDCP 1.4 | ||
| Max. video data rate | 10.2 Gbps (3.4 Gbps per color) per connection | ||
| |||
| |||
| Video input — HDMI — IN4HDMI | |||
| Number/signal type | HDMI/DVI (HDCP 1.4 compliant) | ||
| Connectors | 4 female HDMI | ||
| Maximum pixel clock | |||
| Inputs 1 and 3 | 165 MHz | ||
| Inputs 2 and 4 | 300 MHz | ||
| Formats | RGB and YCbCr digital video | ||
| Horizontal frequency | 15 kHz to 135 kHz | ||
| Vertical frequency | 24 Hz to 75 Hz | ||
| Resolution range | 640×480 to 3840×2400* 480i, 576i, 480p, 576p, 720p, 1080i, 1080p, 2048×1080, 4096×2160* *4K resolutions are supported up to 30 Hz refresh rate. 4K at 60 Hz is supported using two or four parallel connections. | ||
| |||
| Standards | DVI 1.0, HDMI 1.4, HDCP 1.4 | ||
| Video processing — HDMI — IN4HDMI | |||
| Digital pixel data bit depth | 8, 10, or 12 bits per channel | ||
| Colors | 1.07 billion (10-bit processing with full 4:4:4 sampling) | ||
| Video input — SMD — IN SMD 100 | |||
| Number/signal type | Up to 30 H.264/AVC digital video over IP (quantity dependent on stream resolution) | ||
| Connectors | 2 shielded RJ-45 (decoding capability distributed equally between connections) | ||
| Ethernet data rate | 10/100/1000Base-T | ||
| Streaming protocols | |||
| Pull streams | RTP/RTCP (RFC 3550), RTSP (RFC 2326), interleaved RTSP (RTP/RTSP), RTP/RTSP tunneled through HTTP | ||
| Push streams | MPEG-2 TS/UDP (ISO/IEC 13818-1), MPEG-2 TS/RTP (RFC 2250), Direct RTP (RFC 3984) | ||
| Stream discovery | SAP (RFC 2974), SDP (RFC 4145, RFC 4566) | ||
| Transport | TCP, UDP, multicast IGMPv2 (RFC 2236), IGMPv3 (RFC 3376), SSM (RFC 3569, 4607), or unicast (pull streams only) | ||
| Network protocols | ARP, DHCP, DNS, HTTP, HTTPS, ICMP (ping), SSH, SSC, Telnet, TLS | ||
| Container (if included) | MPEG-2 TS (MPEG-2 part 1 or ISO/IEC 13818-1 or ITU-T Rec. H.222.0) MP4 (MPEG-4 part 14 or ISO/IEC 14496-14) | ||
| Video coding | MPEG4 part 10 (AVC) H.264 BP, MP, HiP to level 4.2 (<25 Mbps over 1 second), MJPEG | ||
| Video processing — SMD — IN SMD 100 | |||
| Maximum average bit rates | 25 Mbps per stream (1 second average) | ||
| Latency | 1.0 second maximum | ||
| Digital sampling | 24-bit, 8 bits per color, 165 MHz pixel clock maximum | ||
| Colors | 16.78 million (8-bit processing) | ||
| Video output — HDMI — OUT4HDMI | |||
| Number/signal type | HDMI/DVI (HDCP 1.4 compliant) | ||
| Connectors | 4 female HDMI | ||
| Peripheral device power | 250 mA per output | ||
| Vertical frequency | 23.98 Hz, 24 Hz, 25 Hz, 29.97 Hz, 30 Hz, 50 Hz, 59.94, 60 Hz | ||
| Scaled resolutions | 1024×768, 1280×768, 1280×800,1280×1024, 1360×768, 1366×768, 1440×900, 1680×1050, 1600×1200, 1920×1200, 2048×1200, 2048×1536*, 2560×1080*, 2560×1440*, 2560×1600*, 3840×2400*, 4096×2400**, CUSTOM 720p, 1080p, 2048×1080, 1920×2160, 2048×2160, 3840×2160*, 4096×2160* *Supported on connectors 2 and 4 only **Requires 4 parallel connections. | ||
| Standards | DVI 1.0, HDMI 1.4, HDCP 1.4 | ||
| Video output — DTP — OUT4DTP | |||
| Number/signal type | 4 DTP, XTP, or HDBaseT (configurable, HDCP compliant) | ||
| Connectors | 4 female RJ-45 | ||
| Termination standard | TIA/EIA T568B | ||
| Vertical frequency | 23.98 HZ, 24 Hz, 25 Hz, 29.97 Hz, 30 Hz, 50 Hz, 59.94 Hz, 60 Hz | ||
| Scaled resolutions | 1024×768, 1280×768, 1280×800,1280×1024, 1360×768, 1366×768, 1440×900, 1400×1050, 1680×1050, 1600×1200, 1920×1200, 2048×1200, 2048×1536*, 2560×1080*, 2560×1440*, 2560×1600*, 3840×2400*, 4096×2400**, CUSTOM 720p, 1080p, 2048×1080, 1920×2160, 2048×2160, 3840×2160*, 4096×2160* *Supported on connectors 2 and 4 only **Requires 4 parallel connections. | ||
| Standards | DVI 1.0, HDMI 1.4, HDCP 1.4 | ||
| Communications — External device (pass-through, unidirectional or bidirectional) (RS-232/IR over TP) | |||
| |||
| Serial control pass-through ports | |||
| “Over TP” output | RS-232 via (4) 3.5 mm, 5-pole captive screw connectors (shared with IR ports) | ||
| Baud rates | 9600, 19200, 38400, 115200 baud | ||
| Protocol | 6 – 8 data bits 1 or 2 stop bits no parity (default), even or odd parity flow control = XON, XOFF, none | ||
| Serial control pin configuration | 1 = Tx, 2 = Rx, 3 = Gnd | ||
| IR pass-through control ports | TTL level (0 to 5 V) modulated infrared control from 30 kHz up to 60 kHz | ||
| “Over TP” output | (4) 3.5 mm, 5-pole captive screw connector (shared with RS-232 port) | ||
| IR control pin configuration | 3 = Gnd, 4 = IR Tx, 5 = IR Rx | ||
| Communication — Control | |||
| Serial control port | 1 RS-232 on 3-pole captive screw connector on rear panel | ||
| Baud rate and protocol | 9600, 8-bit, 1 stop bit, no parity (default) | ||
| Pin configurations | 1 = Tx, 2 = Rx, 3 = Gnd | ||
| Ethernet ports | 2 female RJ-45 | ||
| Ethernet default settings | Link speed and duplex level = autodetected LAN A IP address = 192.168.254.254 LAN B IP address = 192.168.1.254 Subnet mask = 255.255.255.0 Gateway = 0.0.0.0 DHCP = Off | ||
| Ethernet data rate | 10/100/1000Base-T, half/full duplex with autodetect | ||
| Protocols | ARP, DHCP, ICMP (ping), TCP/IP, Telnet, HTTP, SMTP | ||
| USB control port | 1 female USB mini-B on rear panel | ||
| Program control | Extron Video wall Configuration Software (VCS) for Windows® Extron Simple Instruction Set™ (SIS™) Telnet | ||
| Communication — Setup | |||
| Number/signal type | 1 HDMI | ||
| Connector | 1 female HDMI | ||
| Vertical frequency | 24 Hz to 60 Hz | ||
| Resolutions | 640×480 to 1920×1200 | ||
| USB control ports | 3 USB type A | ||
| USB standards | USB 2.0, USB 1.1, USB 1.0 compatible | ||
| USB data rates | Low speed (1.5 Mbps), full speed (12 Mbps) | ||
| General | |||
| Power supply | |||
| Quantum Ultra 610 | Internal, primary and redundant*, hot-swappable Input: (2) 100-240 VAC, 50-60 Hz *A redundant power supply is standard. | ||
| Quantum Ultra 305 | Internal Input: 100-240 VAC, 50-60 Hz | ||
| Remote power capability | OUT4DTP supports up to four endpoints if 48 watts of power is provided on DTP POWER connector (remote power not available in XTP and HDBaseT modes) | ||
| Power consumption | |||
| Quantum Ultra 610 | 60-571 watts (varies with configuration) | ||
| Quantum Ultra 305 | 38-288 watts (varies with configuration) | ||
| Temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +95 °F (0 to +35 °C) / 10% to 90%, noncondensing | ||
| Cooling | Fans, right to left (as viewed from the front panel) | ||
| Thermal dissipation | |||
| Quantum Ultra 610 | 208-1941 BTU/hr (varies with configuration) | ||
| Quantum Ultra 305 | 127-956 BTU/hr (varies with configuration) | ||
| Mounting | |||
| Rack mount | Yes | ||
| Enclosure type | Metal | ||
| Enclosure dimensions | |||
| Quantum Ultra 610 | 10.5″ x 17.5″ W x 22.3″ D (6U high, full rack wide) (267 mm H x 445 mm W x 566 mm D) (Depth excludes connectors and handles. Width excludes built-in rack ears.) | ||
| Quantum Ultra 305 | 5.25″ H x 17.5″ W x 19″ D (3U high, full rack wide) (133 mm H x 445 mm W x 483 mm D) (Depth excludes connectors and handles. Width excludes built-in rack ears.) | ||
| Product weight | |||
| Quantum Ultra 610 | 59.8 lbs (28 kg), fully populated | ||
| Quantum Ultra 305 | 35.9 lbs (16 kg), fully populated | ||
| Vibration | ISTA/NSTA 1A in carton (International/National Safe Transit Association) | ||
| Regulatory compliance | CE, c-UL, UL, PSE, RoHs, and WEEE | ||
| Product warranty | 3 years parts and labor | ||
